Arlington, Texas Parking Lot StripingArlington is a city in the Dallas–Fort Worth metropolitan area. According to the 2010 census results, the city had a population of 365,438, making it the third-largest municipality in the Metroplex. Arlington is the 50th largest city in the United States and the seventh-largest city in Texas. Family Fun Activities To Do While Visiting Arlington
Located approximately 12 miles east of downtown Fort Worth and 20 miles west of downtown Dallas, Arlington is home to many exciting attractions.
Speed Bumps In Your Parking Lot
What are Speed Bumps & Which Traffic Control Device Should You Install In Your Parking Lot?
Speedbumps belong to the category of traffic control devices which are used to slow down the speed of traffic. These are used all over the world, and their primary use is in areas where a low-speed limit needs to be followed. Speed bumps have proven to be very useful in controlling the speed of the cars that drive over them. The height of a usual speed bump lies between three and four inches. The length of the bumps can vary, however. Usually some space is left between the bump and the edge of the road. There are many other variations when it comes to speed control devices. Some of which are speed humps, speed cushions, and speed tables. Why You Should Hire a Professional Speed bumps are made of rubber, plastic, asphalt, metal, or concrete. If they’re made of rubber or plastic, it’s easy to get them installed on existing surfaces for a quick and effective setup. Despite being a simple task, there are some basic instructions that need to be followed before installation. If these steps are not followed, a severe accident can happen. The surface where the bump will be fitted should be clean, dry, and smooth. If there is any damage, it should be repaired before a speed bump is installed. Speed bumps should lie flat on the surface. Once the position is marked, speed bumps should be drilled and fitted on the ground. When to Replace Speed Bumps in Your Parking LotSince most speed bumps are made of plastic or metal, they are subject to wear over time. However, their ease of installation makes them the best candidate to be replaced quickly and effectively. Once you see that the speed bumps in your parking lot are worn out due to excess traffic crossing over them, you can get it replaced the same day within a few minutes. In parking lots, it is necessary to install speed bumps so that no vehicle can speed and can cause potential damage to a car or a pedestrian. It is best to seek the services of a professional who can decide which material and size will be best for you to use in your parking lot before you make your decision. Current Weather in Arlington
0 Comments
Leave a Reply. |
Archives
March 2020
Categories |